Datalogic DX8200A-3010 Manual de instalación descargar pdf (Pagina 8)

viii

Warning labels indicating exposure to laser light and the device classification are applied

onto the body of the scanner (Figure A):

LASER LIGHT

DO NOT STARE INTO BEAM

CLASS 2 LASER PRODUCT

MAXIMUM OUTPUT RADIATION 1 mW

EMITTED WAVELENGTH 630~680 nm

TO EN 60825-1:2001

CAUTION-CLASS 3B LASER LIGHT WHEN OPEN

AVOID EXPOSURE TO BEAM

LASER LIGHT EMITTED

FROM THIS

APERTURE

Model No. Amp.

Serial No.

DATALOGIC AUTOMATION S.r.l. - Via Lavino 265

40050 Monte San Pietro - Bologna - Italy

Manufactured Volt

This product conforms to the applicable requirements

of 21CFR1040 at the date of manufacture.

Warning and Device Class Labels Device Identification Label

Disconnect the power supply when opening the device during maintenance or installation to

avoid exposure to hazardous laser light.

The laser diodes used in this device are classified as Class 3B laser products according to

EN 60825-1 regulations and as Class IIIb laser products according to CDRH regulations. Any

violation of the optic parts in particular can cause radiation up to the maximum level of the

laser diode (30 mW at 630~680 nm).

POWER SUPPLY

This product is intended to be installed by Qualified Personnel only.

For DX8200A VDC models:

- This scanner is intended to be supplied by either a UL Listed power supply marked 'Class

2' or 'LPS', output rated 20 - 30 V dc, minimum 1.5 A or by a UL Listed computer with

LPS outputs.

- This scanner must be supplied by a Class II Power Supply Unit conforming to the

EN 60950 safety regulation.

LINE FUSE REPLACEMENT (VAC MODELS ONLY)

CAUTION

Caution – double pole/neutral fusing.

For continued protection against risk of fire, replace with same type and

rating of fuse (250V, 3.15 A).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 138 139

Sin comentarios

Datalogic DX8200A-3010 Manual de instalación Pagina 8