Datalogic DS2100N Manual de instalación descargar pdf (Pagina 14)

DS2100

• programmable in 4 different operating modes to suit the most various barcode

reading system requirements.

• code verifier

• low power consumption.

The DS2100 uses a solid state laser diode as a light source; the light emitted has a

wavelength between 630 and 680 nm. Refer to the section “Safety precautions” at

the beginning of this manual for information on laser safety.

The protection class of the enclosure is IP65, the reader is therefore suitable for

industrial environments where high protection against harsh external conditions is

required.

The four LEDs on the side of the scanner indicate the following:

PWR/TXD LED (red) (Figure A, 5) indicates the reader is connected to the

power supply or, when blinking (green), data transmission.

GOOD READ LED (red) (Figure A, 3) is used to signal the possibility of a

successful barcode reading.

EXT TRIG LED (yellow) (Figure A, 4) indicates external trigger activity. Refer

to par. 2.3.4.

LASER ON LED (green) (Figure A, 2) indicates laser ON state.

The screw holes on the body of the reader are for mechanical fixture (Figure A, 1).

1.3 ACCESSORIES

The following accessories are available on request:

Name Description Part Number

GFC-2100 90° Reading Device 93A201000

GFC-2000 105° reading Device 93A201080

INT-22 20 mA Current Loop Interface Board 93A151020

C-BOX 100/200 Connection Box 93ACC1510, 93ACC1520

C-BOX 300/310 Connection Box Profibus 93A301000, 93A301030

MEP-542/543 Photocell kit NPN/PNP 93ACC1727, 93ACC1728

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Sin comentarios

Datalogic DS2100N Manual de instalación Pagina 14