Datalogic DS4300 Manual de instalación descargar pdf (Pagina 16)

C-BOX 100

2.4 ELECTRICAL CONNECTIONS AND SETUP

The following figure shows the typical layout. The dotted line in the figure refers to an

optional hardware configuration.

SCANNER

System Cables

Scanner

Auxiliary

Interface

TX DATA

EXT TRIG

GOOD RE AD

POWER ON

Figure 5 – System Layout

A PC can be quickly connected to the C-BOX 100 (and consequently to the scanner

auxiliary interface) through the internal 9-pin connector. This allows monitoring of the

data transmitted by the scanner or configuration through the WinHost utility (see the

scanner Installation Manual for more details). The scanner auxiliary interface signals

are also available on the internal spring clamp connectors.

After making system cabling and switch settings (see sub-paragraphs under 2.4),

connect the scanner to the 25-pin connector on the left side of the C-BOX 100

housing.

Switch ON the C-BOX 100 power switch (see Figure 6). The correct polarity of the

power connection is signaled by the green LED, while the red LED turns on in case

of wrong polarity.

NOTE

Power is supplied to the connected scanner (25-pin connector only)

through an electronic circuit which:

- limits the slew rate of the power supplied to the scanner and,

therefore, the inrush current at the input capacitors;

- provides short circuit protection and over current protection

(automatic retry).

After system functioning has been verified, close the C-BOX 100 using the 4 cover

screws making sure the rubber seal is fitted correctly between the parts of the

housing.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Sin comentarios

Datalogic DS4300 Manual de instalación Pagina 16