Datalogic Jet Manual de usuario descargar pdf (Pagina 56)

DATALOGIC JET™

4. Replace the battery pack by pressing the latch release button and pulling the

battery latch down, and then by inserting it towards the speaker and pressing it

into the Datalogic Jet™ PDA until the battery latch is automatically closed:

CAUTION

When the latch release button is pressed, the PDA automatically

shuts off, in order to retain data during the pack substitution. After

the new pack insertion, be sure that the battery latch has

completely slid over the pack so that the latch release button is

released.

WARNING

Do not incinerate, disassemble, short terminals or expose to

high temperature. Risk of fire, explosion. Use specified charger

only. Risk of explosion if the battery is replaced by an

incorrect type. Dispose of the batteries as required by the

relevant laws in force.

NOTE

In order to guarantee an adequate operating autonomy, when

replacing the battery pack the PDA checks the battery energy level.

If the battery is not sufficiently charged, Datalogic Jet™ does not

turn on (when pressing the ON button).

In this case, either substitute the battery pack with a charged one

(sufficiently charged) or insert Datalogic Jet™ into a powered cradle

or plug it into the direct power supply.

4.3 CLEANING THE PDA

Periodically clean the Datalogic Jet™ PDA with a slightly dampened cloth.

Do not use alcohol, corrosive products or solvents.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 69 70

Sin comentarios

Datalogic Jet Manual de usuario Pagina 56