Datalogic Pegaso in Dock Manual de usuario descargar pdf (Pagina 56)

1 DATALOGIC MEMOR™

BeepType: if set to dual tone, the good read beep is a sequence of high and low

pitch sounds. If set to monotone, the beep is a single pitch sound.

BeepDuration: the time interval, in milliseconds, during which the beeper will sound

when the scanner reads a code. To disable the beeper, set this value to 0.

BeepFrequency: determines the frequency in Hertz of the beeper.

GoodReadSound: is the beep sound emitted when the scanner reads a code.

LedDuration: the length of the good-read led pulse, in milliseconds.

LedPulses: the number of times the good-read led pulse is emitted when the

scanner reads a code.

ContinuousMode: disables the effect of the ScanTimeout parameter.

KeyboardEmulation: if enabled all scanned data are transformed into keyboard

events and can therefore be displayed and saved to a file as if input from the mobile

computer keyboard.

SoftTrigger: when enabled, the laser can be turned on/off by the application

software.

ScanAlwaysOn: enables the scanner for barcode reading independently from the

application software.

GreenSpotDuration: determines the duration (measured in milliseconds) of the

green spot feedback, which provides a “good read” green dot directly on the code,

where the operator usually tends to be looking.

NotPrintableChar: if set to “Remove”, all not printable characters included in the

scanned data are deleted and the final barcode will include only printable characters.

ScanButton: enables/disables the scan button. If the scan button is disabled, the

reader can be triggered under software control.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 129 130

Sin comentarios

Datalogic Pegaso in Dock Manual de usuario Pagina 56