Datalogic A30 Manual de instrucciones Pagina 1

A30 QuickStart Guide Publication # 821002020

A30 QUICKSTART GUIDE 10 MOUNTING THE CAMERA Using the A30 mounting brackets, you can obtain rotation on the various axes of the camera as shown i

CBX ELECTRICAL CONNECTIONS 11 CBX ELECTRICAL CONNECTIONS All A30 cameras can be connected to a CBX500 connection box using a CAB-SCSxx accessory cab

A30 QUICKSTART GUIDE 12 NOTE To avoid electromagnetic interference when the camera is connected to a CBX connection box, verify the jumper posit

INPUTS 13 Figure 9 – RS232 Main Interface Connections Using Hardware Handshaking INPUTS There are two optocoupled polarity insensitive inputs avail

A30 QUICKSTART GUIDE 14 CAUTION Power is available directly to the Input Device, independently from the Power Supply Switch inside the CBX.

INPUTS 15 INPUT 2 CONNECTIONS INPUT 2 CONNECTIONS USING CBX POWER CAUTION Power is available directly to the Input Device, independently from th

A30 QUICKSTART GUIDE 16 OUTPUTS Three optocoupled general purpose outputs are available. The meaning of the outputs can be defined by the user. T

EXTERNAL ILLUMINATORS 17 OUTPUT CONNECTIONS USING EXTERNAL POWER Figure 20 - Output Open Emitter Using External Power Figure 21 - Output O

A30 QUICKSTART GUIDE 18 This table summarizes the External Illuminator wiring and power requirements. CBX/Camera Signal Meaning Vdc 10 to 30 Vdc

SOFTWARE CONFIGURATION 19 Changing the Camera’s IP Address 1. Connect to the device with VPM. 2. Select the Settings tab. 3. Click the General Sy

ii Datalogic Automation, Inc. 6301 West Old Shakopee Rd Suite A Bloomington MN 55438 USA A30™ QuickStart Guide Edited: 07/2013 © 2

A30 QUICKSTART GUIDE 20 3. On the left side of the screen, click Change Adapter Settings. 4. Right click LAN1 or LAN 2 and select Properties.

TECHNICAL FEATURES 21 TECHNICAL FEATURES ELECTRICAL FEATURES Power Supply Voltage 10-30 Vdc ± 20% Consumption (max) 0.8 to 0.27 A, 8 W max.; 0.5

www.datalogic.com

REFERENCES iii REFERENCES CONVENTIONS This manual uses the following conventions: "User" refers to anyone using an A30 camera. "Came

COMPLIANCE iv COMPLIANCE For installation, use, and maintenance, it is not necessary to open the camera. Opening the camera will void the warranty.

GENERAL VIEW 5 GENERAL VIEW A30™ Camera 1 Power Indicator LED 2 Power, Serial Interface, and I/O Connector 3 MAC Address label 4 Et

A30 QUICKSTART GUIDE 6 Figure 1 – Assembling the Camera and Lens 4. To keep dust and dirt off of the lens during mounting, temporarily replac

INDICATORS AND KEYPAD BUTTON 7 Use the PG-120 power Kit (3 versions for European, UK or US plug) and CAB-PG-0002 + BA400 connector to connect the PG

A30 QUICKSTART GUIDE 8 To Reset the Camera 1. Turn off power. 2. Press and hold the Camera Reset button. 3. Turn on power. 4. When all the LED

MECHANICAL DIMENSIONS 9 Figure 4 – Mounting Bracket Overall Dimensions mm [in]