Datalogic DS6300-100-011 Manual de instalación descargar pdf (Pagina 54)

DS6300 REFERENCE MANUAL

4.1 POWER SUPPLY

The supply voltage for correct operation of the scanner must be between 15 and 30 VDC.

The max. power consumption is 20 W including startup current.

Datalogic strongly recommends a minimum 24 Vdc supply voltage when using a

master/slave configuration. Several accessory power supplies are available to power the

DS6300 and reading station components. See par. 1.7.

A security system allows the la

ser to activate only once the motor has reached the correct

rotational speed; consequently, the laser beam is generated after a slight delay from the

power on of the scanner.

DS6300 scanners have power ground GND (25/26-pin connector pin 23, 25, 26) as well as

the cable Shield (25/26-pin connector pin 1) internally connected to the chassis.

300

USER INTERFACE

23/25

GND

V- (Ground)

V+ (20

–

30 V dc)

9/13

HASSIS

Earth Ground

Cha ssis

Figure 53 – Power Supply Using the 25/26-pin Connector

4.2 MAIN SERIAL INTERFACE

The main serial interface is compatible with the following electrical standards:

RS232

RS485 full-duplex

RS485 half-duplex

The main interface type and the relative parameters (baud rate, data bits, etc.) can be

set using the Genius™ utility program or the Genius™ based Host Mode Programming

procedure. For more details refer to the section "Main Serial Port" in the Genius™

Help On Line.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 128 129

Sin comentarios

Datalogic DS6300-100-011 Manual de instalación Pagina 54