Datalogic Gryphon BT100 Manual descargar pdf (Pagina 21)

Gryphon™ BT Cordless Reading Systems

Setup for Gryphon™ BT as Master

A Gryphon™ BT is Master when the remote Bluetooth

device is Slave, i.e. with

a Bluetooth

barcode printer.

Once set as Master, a Gryphon™ BT reader must be configured with the

address of the Slave device to which it wants to communicate. As Master it can

initiate a connection with only one Slave device.

By default, at startup the reader initializes the communication with the Slave. If

the connection is successful, the reader can send barcodes to the Slave device.

If the connection is not successful, you can attempt a connection manually by

double-clicking the reader trigger. Radio connections can also be managed

manually as described in the Gryphon™ BT Reference Manual on the

configuration CD-ROM.

During the request of radio connection or disconnection with a remote

Bluetooth

Slave device, the reader emits a series of ticks and short blinks of

the blue LED.

The following figure shows an example Gryphon™ BT Master application.

To configure the Gryphon™ BT as Master follow the given procedure.

Note: for the hexadecimal character selection of step 4, use the Hex/Numeric

table on the following page.

Restore Gryphon™ BT Default

Ì$+$*oÎ

Set Gryphon™ BT as Master

Ì$+QT1$-cÎ

Barcode Printer

(Bluetooth

device)

Slave

Master

Gryphon™ BT

reader

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Sin comentarios

Datalogic Gryphon BT100 Manual Pagina 21