Datalogic Gryphon BT100 Manual descargar pdf (Pagina 24)

DATALOGIC

GRYPHON™ BT DEFAULT CONFIGURATION

USB

DATA FORMAT: code identifier disabled, no field adjustment, code length not

transmitted, character replacement disabled, address stamping = disabled,

address delimiter = disabled.

USB KEYBOARD: USA keyboard, inter-character and inter-code delays

disabled.

USB COM: no handshaking, delay disabled, rx timeout 5 sec., ack/nack

disabled, serial trigger lock disabled.

Default Headers and Terminators for each USB mode:

- USB-KBD: no header, terminator = ENTER

- USB-KBD-ALT-MODE: no header, terminator = CR

- USB-COM: no header, terminator = CR-LF

- USB-IBM-TABLE TOP: not applicable

- USB-IBM-HAND HELD: not applicable

RS232

Standard

9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking, delay disabled,

rx timeout 5 sec., ack/nack disabled, serial trigger lock disabled;

DATA FORMAT: code identifier disabled, no field adjustment, code length not

transmitted, no header, terminator = CR-LF, character replacement disabled,

address stamping = disabled, address delimiter = disabled,

Nixdorf Mode A

9600 baud, parity odd, 8 data bits, 1 stop bit, handshaking hardware

(RTS/CTS), delay disabled, rx timeout 9.9 sec., ack/nack disabled, serial

trigger lock disabled;

DATA FORMAT: code identifier enabled, no field adjustment, code length not

transmitted, no header, terminator = CR, character replacement disabled,

address stamping = disabled, address delimiter = disabled,

Fujitsu

9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking, delay disabled,

rx timeout 2 sec., ack/nack disabled, serial trigger lock disabled;

DATA FORMAT: code identifier enabled, no field adjustment, code length not

transmitted, no header, terminator = CR, character replacement disabled,

address stamping = disabled, address delimiter = disabled,

ICL

9600 baud, parity even, 8 data bits, 1 stop bit, handshaking RTS always on,

delay disabled, rx timeout 9.9 sec., ack/nack disabled, serial trigger lock

disabled;

DATA FORMAT: code identifier enabled, no field adjustment, code length not

transmitted, no header, terminator = CR, character replacement disabled,

address stamping = disabled, address delimiter = disabled,

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comentarios a estos manuales

Sin comentarios

Datalogic Gryphon BT100 Manual Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Lectores De Códigos De Barras Datalogic Gryphon BT100