Datalogic Magellan 3300HSi Manual de instrucciones Pagina 10
- Pagina / 208
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Getting Started
2
Magellan
TM
3300HSi
Connecting the Scanner
The scanner kit you ordered to match your interface should provide a compatible cable for your
installation. Alternatively, if your scanner receives Power Off the Terminal (POT) it might be
possible to connect using a cable from a previously existing installation (except for USB). If you
wish to connect using an existing cable, but cannot use POT, a short adapter cable is available.
Check with your technical support representative about compatibility before connecting. Use
the appropriate instructions below when you’re ready to connect the scanner to the terminal, PC
or other host device.
Upon completing the connection via the appropriate inter
face instructions below, proceed to
the
Interface Related Features section of this manual and scan the bar code to select the correct
interface type.
RS-232 Serial Connection —
Turn off power to the terminal/PC and connect the scanner to the
terminal/PC serial port via the RS-232 cable as shown in
Figure 1a. If the terminal will not sup-
port POT (Power Off the Terminal) to supply scanner po
wer, use the approved power supply
(AC Adapter) as shown in
Figure 1b. Plug the AC Adapter barrel connector into the socket on
the RS-232 cable connector and the AC Adapter plug into
a standard power outlet.
Figure 1
. Connecting the Scanner
U
S
B
U
S
B
R
S
-
2
3
2
I
B
M
or...
or...
Power Off
the Terminal
(POT)
Terminal (PC)
To Terminal (PC)
To Terminal (PC)
Keyboard Wedge, RS-232 and USB Cables
Powered by AC Adapter
Other Non-POT Cables
Powered by AC Adapter
via short adapter cable
R
S
-
2
3
2
a
b
c
Keyboard
Wedge
- Magellan 1
- 3300HSi 1
- Product Reference Guide 1
- Table of Contents 3
- 3200VSi 4
- Product Reference Guide 3 5
- Chapter 1 9
- Getting Started 9
- Connecting the Scanner 10
- Error Codes 12
- Installation 12
- 5 13
- Figure 3. Countertop Cutouts 13
- LED and Beeper Indicators 14
- Programming 16
- Bar Code Mask 17
- LED Class 18
- Chapter 2 19
- General Features 19
- Composite label 21
- Scanner Button Options 22
- Camera Button Mode 23
- LED Level 24
- Auxiliary Port Mode 25
- Auxiliary Port Baud Rate 26
- START / END 27
- PROGRAMMING bar codes 27
- Sleep Mode 28
- Sleep Mode — cont 29
- Wake Up Intensity 30
- Wake Up Intensity — cont 31
- ERI Timeout 33
- Good Read: When to Indicate 34
- Good Read Beep Control 35
- Good Read Beep Frequency 35
- Good Read Beep Length 36
- Good Read Beep Volume 37
- Cell Phone Mode 38
- Chapter 3 39
- Image Capture 39
- Image Compression 42
- Image Format 42
- Image Size 43
- Image Brightness 44
- Image Contrast 44
- Chapter 4 45
- Interface Related Features 45
- Interface Selection 47
- Interface Selection — cont 48
- Interface Features 49
- Interface Features — cont 50
- RS-232 Interface Features 51
- Hardware Flow Control 53
- Intercharacter Delay 54
- Intercharacter Delay — cont 55
- Software Flow Control 55
- Host Echo 56
- Host Echo Quiet Interval 57
- Signal Voltage: Normal/TTL 58
- RS-232 Invert 59
- Beep on ASCII BEL 59
- Beep on Not on File 60
- ACK NAK Options 61
- ACK Character 62
- NAK Character 62
- Retry on ACK NAK Timeout 63
- ACK NAK Timeout Value 63
- ACK NAK Retry Count 64
- ACK NAK Error Handling 65
- Single Cable RS-232 66
- 59 67
- RTS CTS Selection = 67
- Single Cable RS-232 Use BCC 68
- Single Cable RS-232 Use STX 69
- Single Cable RS-232 Use ETX 70
- Single Cable Pacesetter Plus 71
- USB-OEM Interface Features 72
- Keyboard Wedge 73
- USB Keyboard 73
- Keyboard Wedge — cont 74
- 69 77
- Control Characters 77
- Disable Control Characters 77
- USB COM Interface Set-up 79
- Chapter 5 81
- Data Editing 81
- Label ID — cont 85
- Case Conversion 90
- Character Conversion 91
- Chapter 6 93
- UPC-A — continued 94
- Disable/Enable UPC-E 96
- UPC-E — continued 97
- Expand UPC/EAN to GTIN 99
- Disable/Enable EAN-13 100
- Check Digit Transmission 100
- EAN-13 — continued 101
- Disable/Enable EAN-8 102
- EAN-8 — continued 103
- EAN Two-Label 104
- Price Weight Check Digit 105
- Symbologies 106
- Add-ons — continued 107
- UCC/EAN 128 Emulation 108
- GS1-128 Emulation 109
- Length Control 110
- Coupon Read Control 111
- GS1 DataBar Limited 112
- Disable/Enable Code 39 113
- Check Character Calculation 113
- Check Character Transmit 114
- Start/Stop Characters 114
- Code 39 Full ASCII 115
- Code 39 — continued 116
- Code 32 Italian Pharmacode 117
- Code 128 119
- Code 128 — continued 120
- Interleaved 2 of 5 122
- Check Digit Calculation 123
- Check Digit Transmit 123
- Disable/Enable Codabar 125
- Check Character Verification 125
- Codabar — continued 127
- Start/Stop Character Match 129
- Disable/Enable Code 93 129
- Code 93 — continued 130
- Disable/Enable MSI 131
- MSI Check Character Transmit 131
- MSI — continued 132
- 2D Symbologies 135
- Disable/Enable PDF 417 136
- PDF 417 — continued 137
- Micro PDF 417 139
- Micro PDF 417 — continued 140
- Datamatrix 142
- Datamatrix — continued 143
- Disable/Enable QR Code 145
- QR Code — continued 146
- Maxicode 148
- Maxicode — continued 149
- Disable/Enable Aztec 151
- Aztec — continued 152
- Composite Labels 154
- 147 155
- Advanced Decoding Features 157
- UPC/EAN Quiet Zone 158
- Chapter 9 159
- References 159
- Global Prefix/Suffix 160
- Label ID 161
- Appendix A 163
- Product Specifications 163
- Physical Properties 164
- Electrical Parameters 164
- Environmental Parameters 164
- Other Parameters 164
- Appendix B 165
- Cable Pinouts 165
- Appendix C 167
- Alpha-Numeric Pad 167
- Appendix D 169
- Factory Default Settings 169
- Appendix E 175
- 171 179
- Table 6 179
- Table 7 180
- Japanese DOS Function Key Map 180
- 173 181
- Appendix F 183
- Host Commands 183
- Appendix G 185
- Sample Symbols 185
- 1D Symbol Samples — continued 186
- 2D Sample Symbols 187
- Composite Sample Symbols 188
- Appendix H 189
- Autorun File Processing 190
- From Scanner to microSD Card 191
- From microSD Card to Scanner 192
- 185 193
- By Autorun file 193
- Appendix I 195
- 189 197
- 191 199
- Code 39-Pharmacode 200
- I 2 of 5 200
- AIM Formats 203
- 5-Digit Supplemental 204
- Code 128 Supplemental 204
- Bookland 204
- RSS Expanded 205
- Code 128 / EAN128 206
- ASCII Character Set 207
- Datalogic ADC, Inc 208
Relacionado con productos y manuales para Lectores De Códigos De Barras Datalogic Magellan 3300HSi
(24 paginas)
(94 paginas)
(2 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.135 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales