
Interface Related Features
62
Magellan
TM
3300HSi
Single Cable RS-232 Use ETX
Enables/disables the ability of the scanner to use ETX.
START / END
PROGRAMMING bar codes
Disable ETX
Enable ETX
DEFAULT
Set Single Cable RS-232 ETX Character
Allows selection of the ETX character.
To specify the ETX Character:
1. Scan the START/END bar code.
2. Scan the bar code, SET SINGLE CABLE RS-232 ETX CHARACTER below. You’ll need
to
cover any unused bar codes on this and the facing page to ensure the scanner reads only
the bar code you intend to scan.
3. Scan the appropriate characters/digits from the keypad
in Appendix C, Alpha-Numeric Pad
that represent the decimal designation for the desired character. A table containing the
ASCII Character
Set and their corresponding hex values is available in the inside back
cover of this manual. ASCII parameters must be input by scanning decimal digits for each
character. Pad all numbers with leading zeroes to yield a three-digit entry (001-127).
Thus, to set a single character value of A, bar codes containing the digits ‘0’, ‘6’ and ‘5’
must be scanned. The selectable range for this option is any decimal value from 001 to
127.
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scan
ned.
SET SINGLE CABLE RS-232 ETX CHARACTER
Comentarios a estos manuales