Datalogic QLM700 Manual de instrucciones descargar pdf (Pagina 23)

RAPID CONFIGURATION

STEP 7 – TEST MODE

Use a code suitable to your application to test the reading performance of the system.

Alternatively, you can use the Datalogic 1D/2D Test Chart (Code 39, Data Matrix ECC 200).

1. Enter the Test function by pressing and holding the X-PRESS™ push button until the

Test LED is on.

2. Release the button to enter the Test function.

Once entered, the Bar Graph on the five LEDs is activated and if the reader starts

reading codes the Bar-Graph shows the Good Read Rate. In case of no read condition,

only the STATUS LED is on and blinks.

green

yellow

red

Figure 12 – X-PRESS™ Interface: Test Function

3. To exit the Test, press the X-PRESS™ push button once.

NOTE

By default, the Test exits automatically after three minutes.

The Bar Graph has the following meaning:

95%

75%

60%

40%

20%

Figure 13 – Test Bar Graph

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 141 142

Sin comentarios

Datalogic QLM700 Manual de instrucciones Pagina 23