Datalogic POWERSCAN PBT7100 guide Especificaciones Pagina 306
- Pagina / 352
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
BT Features
296 PowerScan® PBT7100 Cordless
BT Address Stamping
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio information to be transmitted to the host and,
if so, at what position with respect to the label data.
Options are:
Do Not Include — Do not include source-radio ID
Prefix — Include source-radio ID as prefix
NOTE
When included as a prefix, the source-radio ID is displayed after all label for-
matting has been applied.
The 6 byte hex address is sent as 12 ascii characters, ie, an address of:
00 06 66 00 1A ED
will be sent as (shown in hex):
30 30 30 36 36 36 30 30 31 41 45 44
ENTER/EXIT PROGRAMMING MODE
Source Radio Address Transmission = Do Not Include
Source Radio Address Transmission = Prefix
DEFAULT
- PowerScan 1
- PBT7100 Cordless 1
- Product Reference Guide 1
- Table of Contents 3
- 2PowerScan 4
- 4PowerScan 6
- 6PowerScan 8
- 8PowerScan 10
- PD7100 Corded 10
- Chapter 1 11
- Introduction 11
- Manual Conventions 12
- References 12
- Technical Support 13
- 4 PowerScan® PBT7100 Cordless 14
- Chapter 2 15
- Getting Started 15
- Connect the Base Station 16
- Figure 3) on the Base Sta 17
- Base Station 18
- Paging Feature 19
- Programming 19
- Configure Other Features 20
- Chapter 3 21
- Interfaces 21
- Select RS-232 OPOS 22
- Select KBD-IBM-M 24
- Global Interface Features 25
- USB Suspend Mode 26
- Chapter 4 27
- General Features 27
- Label Gone Timeout 29
- Label Gone Timeout — cont 30
- Sleep Mode Timeout 31
- LED and Beeper Indicators 33
- Good Read: When to Indicate 34
- Good Read Beep Type 35
- Good Read Beep Frequency 36
- Good Read Beep Length 36
- Good Read Beep Volume 38
- Good Read LED Duration 39
- 2 seconds 40
- Scanning Features 41
- Scan Mode — continued 42
- Stand Mode Triggered Timeout 43
- Scanning Active Time 45
- Scanning Active Time — cont 46
- Flash On Time 47
- Flash On Time — cont 48
- Flash Off Time 49
- Flash Off Time — cont 50
- Stand Mode Sensitivity 51
- Laser Pointer Control 52
- Laser Pointer Period 53
- Laser Pointer Period — cont 54
- Green Spot Duration 55
- Chapter 5 57
- RS-232 ONLY Interface 57
- Baud Rate — continued 58
- Data Bits 59
- Stop Bits 60
- Handshaking Control 62
- Chapter 6 63
- RS-232/USB-Com Interfaces 63
- Intercharacter Delay 64
- Intercharacter Delay — cont 65
- Beep On ASCII BEL 66
- Beep On Not on File 66
- ACK NAK Options 67
- ACK Character 68
- ACK Character — cont 69
- NAK Character 70
- NAK Character — cont 71
- ACK NAK Timeout Value 72
- ACK NAK Timeout Value — cont 73
- ACK NAK Retry Count 74
- ACK NAK Retry Count — cont 75
- ACK NAK Error Handling 76
- Indicate Transmission Failure 77
- Disable Character 78
- Disable Character — cont 79
- Enable Character 80
- Enable Character — cont 81
- Chapter 7 83
- Keyboard Interface 83
- Country Mode 84
- Country Mode — continued 85
- Caps Lock State 87
- Send Control Characters 88
- Wedge Quiet Interval 89
- Wedge Quiet Interval — cont 90
- Intercode Delay 93
- Intercode Delay — cont 94
- USB Keyboard Speed 95
- Chapter 8 97
- USB-OEM Interface 97
- USB-OEM Device Usage 98
- Chapter 9 99
- 46xx Number of Host Resets 100
- 101
- ENTER/EXIT PROGRAMMING MODE 102
- IBM 46XX Interface 104
- Chapter 10 105
- Data Editing 105
- Please Keep In Mind 106
- Global Prefix/Suffix 106
- No Global Prefix 107
- Global Suffix = 0x0D (CR) 107
- Global AIM ID 108
- Global AIM ID — continued 109
- GS1-128 AIM ID 110
- Label ID 111
- Label ID — continued 114
- Case Conversion 122
- Character Conversion 123
- Chapter 11 125
- Symbologies 125
- Coupon Control 126
- UPC-A Enable/Disable 127
- UPC-A — cont 128
- UPC-E Enable/Disable 130
- UPC-E — cont 131
- GTIN Formatting 134
- EAN 13 Enable/Disable 135
- EAN 13 — cont 136
- EAN-13 ISBN Conversion 137
- EAN 8 Enable/Disable 139
- EAN 8 — cont 140
- UPC/EAN Global Settings 142
- UPC/EAN Correlation 144
- UPC/EAN Reconstruction 144
- UPC/EAN Price Weight Check 145
- UPC-A Minimum Reads 146
- Optional Add-ons 147
- Add-Ons — cont 148
- GS1 DataBar Omnidirectional 158
- GS1 DataBar Expanded 160
- GS1 DataBar Expanded — cont 161
- GS1 DataBar Limited 167
- GS1 DataBar Limited — cont 168
- Code 39 Enable/Disable 169
- Code 39 — cont 170
- Code 39 Stitching 185
- Code 32 Enable/Disable 186
- Code 32 — cont 187
- Code 128 188
- Code 128 — cont 189
- GS1-128 Enable 202
- Interleaved 2 of 5 (I 2 of 5) 203
- I 2 of 5 Minimum Reads 206
- I 2 of 5 Decoding Level 207
- I 2 of 5 Length Control 209
- I 2 of 5 Set Length 1 210
- 06 = Length 1 is 6 Characters 211
- I 2 of 5 Set Length 2 212
- I 2 of 5 Set Length 2 — cont 213
- I 2 of 5 Stitching 215
- Datalogic 2 of 5 216
- Datalogic 2 of 5 — cont 217
- Codabar Enable/Disable 228
- Codabar — cont 229
- Codabar Stitching 245
- Code 11 Enable/Disable 246
- Code 11 — cont 247
- Code 11 Decoding Level 257
- Code 11 Stitching 260
- Standard 2 of 5 261
- Standard 2 of 5 — cont 262
- Standard 2 of 5 Stitching 270
- ISBT 128 271
- ISBT 128 — cont 272
- Code 4 Enable/Disable 273
- Code 4 — cont 274
- Code 5 Enable/Disable 275
- Code 5 — cont 276
- Code 4 and 5 Decoding Level 277
- Follett 2 of 5 280
- Chapter 12 283
- BT Features 283
- BT Beeper Features 284
- Beep Frequency 285
- Beep Duration 286
- Beep Duration — cont 287
- Beep Volume 288
- BT Base Station Beep 289
- Disconnect Beep 289
- BT Leash Alarm 290
- BT Leash Alarm — cont 291
- Flash Update 292
- Configuration Update 293
- Configuration Update — cont 294
- Battery Charge Mode 295
- Powerdown Timeout 296
- Powerdown Timeout — continued 297
- BT Poll Rate 298
- BT Poll Rate — cont 299
- Batch Features 300
- Batch Features — cont 301
- BT Security Features 301
- BT Pin Code — cont 303
- BT Security Mode 304
- BT SPP Mode 305
- BT Address Stamping 306
- 00 = No Delimiter Character 308
- Appendix A 309
- Standard Cable Pinouts 312
- Appendix B 313
- DataBar Omnidirectional 316
- DataBar Expanded 317
- DataBar Limited 317
- UCC-EAN 128 318
- Interleaved 2 of 5 318
- Appendix C 323
- BT Beeper Indications 325
- BT LED Indications 326
- Error Codes 327
- Appendix D 329
- 00246897634 330
- 7554628485 330
- 74759330108 330
- DataBar (RSS) 331
- Appendix E 333
- Appendix F 337
- Product Reference Guide 328 338
- Product Reference Guide 329 339
- Product Reference Guide 330 340
- Product Reference Guide 331 341
- Digital Interface 342
- Digital Interface — cont 343
- IBM31xx 102-key 344
- IBM31xx 102-key — cont 345
- Product Reference Guide 336 346
- IBM XT — cont 347
- Product Reference Guide 339 349
- ASCII Chart 351
Relacionado con productos y manuales para Lectores De Códigos De Barras Datalogic POWERSCAN PBT7100 guide
(32 paginas)
(2 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.148 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales