Datalogic PowerScan PBT9500 Especificaciones descargar pdf (Pagina 41)

100

101

Enter/Exit Programming Mode

Product Reference Guide

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one

character and the beginning of the next. The delay can be set within a range

of zero (0) to 990 milliseconds in 10ms increments. A setting of zero speci-

fies no delay.

See page 281 for more information.

$CR2IC00(CR)

Intercharacter Delay = No Delay

$CR2IC

Select Intercharacter Delay Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in

Appendix D, Keypad

repre-

senting your desired character(s). End by scanning

the ENTER

/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort and

not save the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

00 = No Intercharacter Delay

Beep On ASCII BEL

When this parameter is enabled, the reader issues a beep when a <BEL>

character is detected on the RS-232 serial line. <BEL> is issued to gain a

user's attention to an illegal entry or other important event.

$CR2BB00(CR)

Beep On ASCII BEL = Disable

DEFAULT

$CR2BB01(CR)

Beep On ASCII BEL = Enable

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 361 362

Comentarios a estos manuales

Sin comentarios

Datalogic PowerScan PBT9500 Especificaciones Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Lectores De Códigos De Barras Datalogic PowerScan PBT9500