Datalogic PowerScan PBT9500 Especificaciones descargar pdf (Pagina 44)

Enter/Exit Programming Mode

PowerScan™ PD9530/PBT9500/PM9500

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK charac-

ter from the host following label transmissi

on. The selectable timeout range

is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments. A

selection of 0 disables the timeout.

See page 276 for more information on setting this feature.

$CR2AT

Select ACK NAK Timeout Value Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in

Appendix D, Keypad

repre-

senting your desired character(s). End by scanning

the ENTER/EXIT bar

code again.

Make a mistake? Scan the CANCEL bar code to abort

not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

01 ACK NAK Timeout value is 200ms

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label trans-

mission due to a retry condition. The selectable

range is from 1 to 254

retries. A selection of 0 disables the count, and a selection of 255 specifies

unlimited retries. See page 277 for more information.

$CR2AR

Select ACK NAK Retry Count Setting