Datalogic GWY-01-PBS-01 Especificaciones descargar pdf (Pagina 25)

GWY-01-DNT-01 MANUAL – REV. 02 CHAPTER 2:

GATEWAY OVERVIEW

PAGE 25 OF 67

2.6 GATEWAY AND SUBNET NODE NAMING

The Gateway can store a 64-byte ASCII string for each of the 16 Subnet Nodes and

one 64-byte ASCII string for the Gateway itself. These text strings can be used to

assign logical or “user friendly” names to the Gateway and its Subnet Nodes.

For example, you could assign the Gateway a logical name such as “PRODUCTION

LINE 1” and then name the controller connected to Subnet Node 01 “PRODUCTION

STATION 1.” The controller at Subnet Node 02 could then be named “PRODUCTION

STATION 2” (and so forth).

Gateway and Node names can be retrieved and edited by issuing specific commands

to the Gateway (which are covered later in this manual). See the table below for

specific CBx protocol command ID numbers.

Gateway and Node Naming – CBx Command IDs

GATEWAY NODE

GET

NAME

Command 0x11 Command 0x30

SET

NAME

Command 0x21 Command 0x40

Table 2-4: Gateway and Node Naming – CBx Command IDs

Gateway and Node naming can also be accomplished through the Cobalt Dashboard

software utility (see Chapter 2, Section 2.7.1, “Cobalt Dashboard” for information).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 66 67

Sin comentarios

Datalogic GWY-01-PBS-01 Especificaciones Pagina 25