Datalogic GWY-01-PBS-01 Especificaciones descargar pdf (Pagina 51)

GWY-01-DNT-01 MANUAL – REV. 02 CHAPTER 5:

DEVICENET INTERFACE

PAGE 51 OF 67

The following images display the Input and Output properties tabs (in RSNetWorx

for DeviceNet) for the 1756-DNB/A DeviceNet Bridge / Scanner Module after running

the Scanner Configuration Applet for a second time. The scanner module, in this

case, only identified one node, the Gateway, at node address 63. The tabs are used

to identify where input and output data is mapped for each identified node. In the

image below, input data is mapped to start at 1:I.Data(0).0 on the PLC.

8 Run the Scanner Configuration Applet and verify the mapping of the address

where the PLC will write input data for the Gateway.

Figure 5-5: 1756-DNB/A Input Properties Tab

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 66 67

Sin comentarios

Datalogic GWY-01-PBS-01 Especificaciones Pagina 51