Datalogic Compact 2D Reader Matrix-2000 Especificaciones descargar pdf (Pagina 6)

COMPLIANCE

For installation, use and maintenance it is not necessary to open the reader.

EMC COMPLIANCE

In order to meet the EMC requirements:

• connect reader chassis to the plant earth ground by means of a flat copper braid shorter

than 100 mm;

• connect the main interface cable shield to pin 1 of the reader 25-pin connector;

• use two clip-on ferrite sleeves (type Stewart 28A2029-0A0) on the main interface cable

near the reader 25-pin connector;

• connect the Ethernet interface cable shield to the reader chassis (for Matrix-21XX only).

POWER SUPPLY

ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT

This product is intended to be installed by Qualified Personnel only.

This product is intended to be connected to a UL Listed Computer which supplies power

directly to the reader or a UL Listed Direct Plug-in Power Unit marked LPS or “Class 2”,

rated 10 to 30 V, minimum 1 A.

LED CLASS

Class 1 LED Product to EN60825-1:2001

CE COMPLIANCE

Warning: This is a Class A product. In a domestic environment this product may cause radio

interference in which case the user may be required to take adequate measures.

WEEE COMPLIANCE

1 2 3 4 5 6 7 8 9 10 11 ... 81 82

Sin comentarios

Datalogic Compact 2D Reader Matrix-2000 Especificaciones Pagina 6