Datalogic DS2100N Manual de usuario Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 34
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
Setup Procedure Using Programming Barcodes
6
1.2 FOR MATRIX 400™ AND MATRIX 410™
1. Perform the setup procedures described in the Quik Reference Guide, including Focus
and Image Density Calibration.
2. Press and hold the X-PRESS™ button to enter the “AutoLearn Mode”. Once button is
pressed, the LED cycle appears as follows:
READY
SETUP
FOCUS
T
ES
T
LEAR
GOOD
TRIGGER
COM
STAT US
READY
SETUP
FOCUS
T
ES
T
LEAR
GOOD
TRIGGER
COM
STAT US
READY
SETUP
FOCUS
T
ES
T
LEAR
GOOD
TRIGGER
COM
STAT US
READY
SETUP
FOCUS
T
ES
T
LEAR
GOOD
TRIGGER
COM
STAT US
Just pressed.
After 2 seconds.
After 8 seconds.
Release the button to
enter the AutoLearn
Mode.
The green LEARN LED
blinks: the AutoLearn
Mode is working.
3. Now, put the barcode related to the planned role and address in front of the reader. The
picture below shows, as example, the reader configuration as “Slave 1”
3
:
4. Once the reader has successfully read the code, the LEDs stay on steady for 2 seconds:
READY
SETUP
FOCUS
T
ES
T
LEAR
GOOD
TRIGGER
COM
STAT US
Successful reading.
3
the barcodes shown are examples, only. Use the barcodes in the Network Layout Barcodes paragraph for the
actual programming.
Slave 1
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Comentarios a estos manuales

Sin comentarios