Datalogic DS2100N Manual de usuario descargar pdf (Pagina 8)

Setup Procedure Using Programming Barcodes

LEARN

1. Press and hold the X-PRESS™ button to enter the “AutoLearn Mode”. Once button is

pressed, the LED cycle appears as follows:



Just pressed.



After 2 seconds.



After 8 seconds.

Release the button to

enter the AutoLearn

Mode.

The green LEARN LED

blinks: the AutoLearn

Mode is working.

2. Now, put the barcode related to the planned role and address in front of the reader. The

picture below shows, as example, the reader configuration as “Slave 1”

3. Once the reader has successfully read the code, the LEDs stay on steady for 2 seconds:

Successful reading.

the barcodes shown are examples, only. Use the barcodes in the Network Layout Barcodes paragraph for the

actual programming.

Slave 1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Sin comentarios

Datalogic DS2100N Manual de usuario Pagina 8