Datalogic DS2100N Manual de usuario descargar pdf (Pagina 7)

Setup Procedure Using Programming Barcodes

1.1 FOR MATRIX 200™ AND MATRIX 210™

AIM

1. Power the reader on. During the reader startup (reset or restart phase), all the LEDs blink

for one second. On the connector side of the reader near the cable, the “POWER ON”

LED (blue) indicates the reader is correctly powered.

2. Enter the Aim/Locate function by pressing and holding the X-PRESS™ push button until

the Aim LED is on. Release the button to enter the Aim function. The aiming system turns

on see below.

FOV



Just pressed.



After 2 seconds.



After 4 seconds.

Release the button to

enter the Aim Mode.

The yellow AIM LED blinks:

the Aim Mode is working.

3. Place the application specific code in front of the reader at the reading distance indicated

for your model in the Reading Features table, centering it in the aiming system indicator.

4. Exit the Aim function by pressing the X-PRESS™ push button once. The aiming system

turns off.

1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

Sin comentarios

Datalogic DS2100N Manual de usuario Pagina 7