Datalogic DS2100N Manual de usuario descargar pdf (Pagina 28)

Setup Procedure Using Programming Barcodes

2.3 IP ADDRESS ALIGNMENT PROCEDURES FOR CONFIGURATION

In order to connect a Matrix reader to VisiSet™ using Embedded Ethernet TCP/IP or CBX

Ethernet TCP/IP, the Ethernet IP Addressing parameters must be aligned between VisiSet™

and the reader.

In order to find the reader using the VisiSet™ "Look For Devices On Network" tool, the

reader and VisiSet™ must be on the same network (not through a sub-network or

router).

The following procedures can be used:

2.3.1 DHCP Enabled

1. Read the CBX Ethernet TCP/IP enabled DHCP enabled barcode or Embedded

Ethernet TCP/IP enabled DHCP enabled barcode using the X-PRESS™ Autolearn

function (as described in chapter 1).

2. In VisiSet select the Ethernet Communication Channel in the Options>Communication

window. Then press the Look For Devices On Network button. The Matrix reader will

appear with its assigned IP Address in the list. If more than one device is found, verify

the correct device by its MAC Address written on the product label.

3. Input the IP address from the list in the IP Address field of the Device Ethernet

Channel Address section of the VisiSet™ Options>Communication window (or

double-click on the device in the list). The IP port number is 51235. Then click Save.

4. Perform a Connect (to device) from VisiSet™.

NOTE

Devices working in DHCP may be assigned different IP addresses at each

powerup, therefore steps 2 - 4 of the above procedure may need to be

repeated at successive connections between VisiSet™ and the reader.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Sin comentarios

Datalogic DS2100N Manual de usuario Pagina 28